|
|
Original SubmitterEdit Dates
Date Uploaded
May 12, 2005, 10:29 pm Last Edited September 8, 2011, 10:07 pm |
DescriptionThis is my coil winder that I recently contructed. I based it off of several different desgins already in articles on this site. So far I have 5/16",1/4",3/16", and 5/32" bent rods made for it. I used the notch in the end method instead of drilling a hole through the rod. I can't believe I hand wound for so long, this is so much easier!!! I do still hand wind sterling though, its too expensive to risk wasting any.Weave(s) Used (Click to View Weave)NoneImages Tags (Click to Search Gallery)Tag(s): Coiling, Crank, Handwind, Setup, Tools |