Submitted ByEdit Dates
Date Uploaded: November 12, 2011, 10:24 pm Last Edited: December 18, 2012, 2:19 pm |
![]() Site Favourites Print this Article |
Triangle
Article © MAIL User: Corvus

This tutorial was written by paula and reproduced here with her kind permission, paula can be contacted here: info[at]pieceofmaille[dot]com
Here's a little tutorial for making the "basic" Triangle (the ones on the left, the other triangles in the picture are just variations of the design).
Rings needed: nine 16 ga 5/16", six 18 ga 1/4", three 18 ga 3/16" and nine 18 ga 5/32"
Step 1
Close six 18 ga 1/4" rings and connect them in pairs of two with 18 ga 5/32" rings as shown.

Step 2
Attach the ends with another 18 ga 5/32" ring.

Step 3
Put a 16 ga 5/16" ring around one of the smaller rings so that goes in between the 18 ga 1/4" rings. This takes a bit of negotiating :).

Here's the side-view:

Step 4
Add two more 16 ga 5/16" rings to fill up the pattern; this is tight and it needs to be so to make the piece rigid.

Step 5
Put two 16 ga 5/16" rings through one of the 18 ga 1/4" ring pairs as shown.

From the side:

Step 6
Repeat on the other sides.

Step 7
Link the just added 16 ga 5/16" rings together at each point with two 18 ga 5/32" rings:

Step 8
Loop a 18 ga 3/16" ring through the two rings you added; make sure the ring will also go through the 16 ga 5/16" 'base' ring and between the two large, vertical rings.

Seen from 'above':

Step 9
Repeat, and you have your triangle :).

This tutorial was made by Paula Kosunen
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=556