Submitted ByEdit Dates
Date Uploaded: September 6, 2009, 8:37 pm Last Edited: January 5, 2013, 4:34 am |
 Add toSite Favourites Print this Article |
Joining Full Persian 6 in 1
(CGI)
Article © MAIL User: JDanks
Joining Full Persian 6 in 1 chains is actually pretty easy, but I didn't get
it right on the first try so I thought these instructions might be useful.
The rings pictured are approximately 1/4" inner diameter, in 0.041" wire. I haven't tried it with other sizes, so this might not work with tighter rings...
Step 1
Line up your chain ends as shown above.
Step 2
Open the blue rings, one at a time, and thread them through both red
rings, making sure that the blue rings go between the darker green rings.
Step 3
Open the darker green rings, one at a time, and thread them through the
lighter green rings.
it right on the first try so I thought these instructions might be useful.
The rings pictured are approximately 1/4" inner diameter, in 0.041" wire. I haven't tried it with other sizes, so this might not work with tighter rings...
Step 1
Line up your chain ends as shown above.
Step 2
Open the blue rings, one at a time, and thread them through both red
rings, making sure that the blue rings go between the darker green rings.
Step 3
Open the darker green rings, one at a time, and thread them through the
lighter green rings.
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=95
