Submitted ByEdit Dates
Date Uploaded: September 6, 2009, 10:10 pm Last Edited: December 19, 2012, 12:23 pm |
 Add toSite Favourites Print this Article |
Celtic Labyrinth
(Unit)
Article © MAIL User: Nárrína
Celtic Labyrinth (Unit) requires four different ring sizes.
(Apologies for any blurry pics.)
When I first made this weave I was using 20ga and 16ga (likely AWG) wire in the following ring sizes:
16ga 6mm ID rings
20ga 4mm ID rings
20ga 3.25mm ID rings
20ga 2mm ID rings
Step 1: Close your largest ring and eight of your second largest rings.
Step 2: Then connect each of the sets of two rings to your largest ring using your second smallest ring size.
Step 3: Fold over the second largest rings as pictured and attach two more of your third ring size (the second smallest rings) into these folded over rings just as they would be in Celtic Visions.
Step 4: Now use your smallest rings. These rings should go through all four of the second smallest rings at the corner of the unit.
(Apologies for any blurry pics.)
When I first made this weave I was using 20ga and 16ga (likely AWG) wire in the following ring sizes:
16ga 6mm ID rings
20ga 4mm ID rings
20ga 3.25mm ID rings
20ga 2mm ID rings
Step 1: Close your largest ring and eight of your second largest rings.
Step 2: Then connect each of the sets of two rings to your largest ring using your second smallest ring size.
Step 3: Fold over the second largest rings as pictured and attach two more of your third ring size (the second smallest rings) into these folded over rings just as they would be in Celtic Visions.
Step 4: Now use your smallest rings. These rings should go through all four of the second smallest rings at the corner of the unit.
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=554
