Submitted ByEdit Dates
Date Uploaded: July 13, 2009, 3:14 am Last Edited: January 31, 2016, 4:27 pm |
 Add toSite Favourites Print this Article |
B8FP
(Sand Worm)
(CGI)
Article © MAIL User: MaxumX
This tutorial will take you through making B8FP (Sand Worm) in 3 easy steps.
Ring size used 1/2in (.500" or 12.7mm ) 14g ( 0.078" or 2.03mm)
First make a chain of Full Persian 6 in 1 about 4" or 5" long. This is going to be the core of the weave.
Next weave a ring through the two side rings on each side as shown. Do not put through the cross-section of the FP; it will be too tight at this AR, but with larger ARs you could do this to tighten it up a bit more.
Now, add your top and bottom rows just as if you were stitching [weave=Box Chain]. Be sure to get the inside ring in there or you'll just have shaggy rings around your FP instead of a Box weave.
When you have done this, it should look like so:
Ring size used 1/2in (.500" or 12.7mm ) 14g ( 0.078" or 2.03mm)
First make a chain of Full Persian 6 in 1 about 4" or 5" long. This is going to be the core of the weave.
Next weave a ring through the two side rings on each side as shown. Do not put through the cross-section of the FP; it will be too tight at this AR, but with larger ARs you could do this to tighten it up a bit more.
Now, add your top and bottom rows just as if you were stitching [weave=Box Chain]. Be sure to get the inside ring in there or you'll just have shaggy rings around your FP instead of a Box weave.
When you have done this, it should look like so:
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=376
