Submitted ByEdit Dates
Date Uploaded: June 8, 2009, 4:09 am Last Edited: December 16, 2012, 8:03 pm |
 Add toSite Favourites Print this Article |
Vipera Berus
(CGI)
Article © MAIL User: MaxumX
This is a weave by Loke. He has done a very good job at posting them. I love them, and I know you will, too. So here is the first one, "Vipera Berus." Loke recommends rings of 1.3 mm, mandrel of 4 mm or an AR of 3.1, in this tut the rings are about AR of 3.04.
Step one: Start off by making a 1 in 1 chain as long as you like. You can always add more to it later. Now arrange it so it looks like a small section of European 4 in 1.
Step two: Now add one ring to each side, one through rings 1 and 3 and the other in 2 and 4. It should look like this:
Step three: similar to step two, but place the ring through backwards and through the rings you added in step two. Like this:
Step four: same as step two, but place the ring through forwards and through the rings added in step three.
Step five: now that you have the basic pattern, just keep adding rings like step three and four. Done.
Step one: Start off by making a 1 in 1 chain as long as you like. You can always add more to it later. Now arrange it so it looks like a small section of European 4 in 1.
Step two: Now add one ring to each side, one through rings 1 and 3 and the other in 2 and 4. It should look like this:
Step three: similar to step two, but place the ring through backwards and through the rings you added in step two. Like this:
Step four: same as step two, but place the ring through forwards and through the rings added in step three.
Step five: now that you have the basic pattern, just keep adding rings like step three and four. Done.
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=343
