Submitted ByEdit Dates
Date Uploaded: May 3, 2008, 6:40 pm Last Edited: December 16, 2012, 8:01 pm |
 Add toSite Favourites Print this Article |
Turkish Round
(CGI)
Article © MAIL User: cohort
This tutorial was rendered using rings of an AR of 4.3. (that is, the ring's internal diameter is 4.3 times the cross section of wire)
You have just completed a single unit of Turkish Round. To extend the piece, simply repeat steps 2 through 4 until you've arrived at the length you desire.
(Tutorial images created with Blender 2.34)
- Make a 1-1 chain loop using 6 rings. (note: the horizontal rings are placeholders only here, they aren't part of the weave proper)
(looking down from the top) - Add 3 rings to the vertical rings. (new rings are yellow, old rings white)
(looking down from the top) - Lifting the new horizontal rings to an upward angle, insert three new rings in the same fashion as last step, but allowing them to 'flop' backwards and pulling them up through the middle.
- Add three more rings, as with Byzantine.
(looking down from the top) | (from the side) |
(looking down from the top) | (from the side) |
You have just completed a single unit of Turkish Round. To extend the piece, simply repeat steps 2 through 4 until you've arrived at the length you desire.
(Tutorial images created with Blender 2.34)
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=303
