sandworm bracelet ?
View previous topic | View next topic >
Post new topic Reply to topic
M.A.I.L. Forum Index -> Weaves Discussion
   
Author Message

Joined: January 29, 2013
Posts: 3
Submissions: 0
Location: Hampstead NC

sandworm bracelet ?
Reply with quote
Posted on Thu Feb 27, 2014 6:39 pm
Link to Post: Link to Post

looking to make a sandworm bracelet for myself just wanted to know if the 7.0 ar has some felx in it or do i need to get some more room it the rings.........please let me know

Joined: August 7, 2013
Posts: 62
Submissions: 0
Location: Philadelphia

Reply with quote
Posted on Thu Feb 27, 2014 11:32 pm
Link to Post: Link to Post

as long as you stay on the higher end on the AR scale, you should be fine.

Check out this thread, it might help

http://www.mailleartisans.org/board/viewtopic.php?p=214926&sid=92441d0651a9533653d9a20ff3cf6b6a

Joined: January 29, 2013
Posts: 3
Submissions: 0
Location: Hampstead NC

Reply with quote
Posted on Fri Feb 28, 2014 8:54 pm
Link to Post: Link to Post

thanks linked388 that is helpfull...i'm going to try14 ga 1/2"id that has ar6.7 in stainless steel ...so thanx agin

Joined: July 25, 2013
Posts: 62
Submissions: 0
Location: Huntington, Indiana, USA

Reply with quote
Posted on Fri Feb 28, 2014 9:05 pm
Link to Post: Link to Post

This thread helped me too...going to try a necklace of B8FP (Sand Worm) in 24awg 1/8" titanium from TRL, listed AR of 7.0.


-Lucidish

Closing rings since 2013-07-27

A jack of all trades, master of none, often times better than a master of one.

Maille Code V2.0 T4.2 R4.1 En.o Fper MFe.s W$ C$ G0.8-2.0 I3.2-9.5 N8.8 Pjt Djt X0 S13 Hn

Joined: August 7, 2013
Posts: 62
Submissions: 0
Location: Philadelphia

Reply with quote
Posted on Fri Feb 28, 2014 10:07 pm
Link to Post: Link to Post

if you both remember, can you post some pictures of the final result?

Post new topic Reply to topic
Jump to:  
Page 1 of 1
All times are GMT. The time now is Mon Jun 24, 2019 8:25 pm
M.A.I.L. Forum Index -> Weaves Discussion
Display posts from previous: