You are not Logged In! -- Please consider creating an account. (It's free!)
This is the BETA version of the Articles Library -- Expect occasional bugs -- Report them to Daemon_Lotos => [Here]
[ Articles Home | Newest Articles | Submit an Article ]
[ Random Article | Search Articles ]

Cabochon Wrapping Using European 4 in 1 and 6 in 1
Article © MAIL User: lorraine

This is a how-to of the way I use European 4 in 1 and European 6 in 1 to wrap a cabochon. You should be very familiar with both those weaves before attempting. There is no glue involved in keeping the cab captured in the wrap. I used a very small cab for this tutorial, only 12x16mm. You can use any size you wish, and round or oval cabs give the best results. The rings are 22awg/2.5mm sterling silver.


STEP 1. To give you a rough idea of how long to make your initial strip of E4-1, wrap a piece of masking tape around the base of the cab and mark where the tape overlaps.
Image: cabwrap1.jpg


STEP2. Remove the tape and measure the length.
Image: cabwrap2.jpg


STEP 3. Make a strip of E4-1 three rings wide. This strip will contract considerably when you start adding your E6-1 edges, so donít measure your strip stretched out like this.
Image: cabwrap3.jpg


STEP 4. Instead, measure your strip bunched up like in this picture. This will still only give you a rough idea of how long to make your strip of E4-1, but itís better than nothing.
Image: cabwrap4.jpg


STEP 5. Now start edging one side of your strip with E6-1. In other words add each ring through three rings instead of just two. I like to leave the rings on the ends hanging. It makes it easier to join the ends later.
Image: cabwrap5.jpg


STEP 6. Check your strip against the cab to see if you need to add some length to it. In this case I did add a few more rows. Thereís lots of guesswork involved in getting the length just right.
Image: cabwrap6.jpg


STEP 7. Now start adding E6-1 to the other edge.
Image: cabwrap7.jpg


STEP 8. Your strip will start curling up into a donut shape. Check it against the cab again to decide if you need to add or subtract from your strip for a snug fit.
Image: cabwrap8.jpg


STEP 9. Now join the ends of your strip. This is why I leave the ends loose. It makes it easier to connect.
Image: cabwrap9.jpg


STEP 10. Finish the edging of E6-1 on one side.
Image: cabwrap10.jpg


STEP 11. Turn the wrap over and start adding the last of the E6-1 to the other side. I wait until I only have two or three rings left to go before I finally slip the cab into the wrap. Iíll warn you now, the last ring will probably be very hard to get in. Itís a tight spot and itís up against the surface of the back of the cab, but it can be done.
Image: cabwrap11.jpg


STEP 12. Yay, you got the last ring in! Hereís the back of my wrapped cab.
Image: cabwrap12.jpg


STEP 13. And hereís the front.
Image: cabwrap13.jpg


What you do with your wrapped cab is now up to you. Have fun with it!

Comments are always welcome.
Lorraine
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=561