Date Uploaded: February 3, 2010, 12:22 pm
Last Edited: January 13, 2013, 8:35 am
Article TagsSpiral Weaves, Weave Tutorials
Print this Article
Article © MAIL User: MaxumX
AR: 5.5 - 7
Blue = Inactive or finished section of the weave
Green = Active or added ring(s)
Red = Interpolated or Gone through ring(s)
Yellow = Orbital or Captive
Let's get right into it then, start off by making a few lengths of 2 in 1 Chain. These will become the attached rows once we have them prepared.
Step Two: Okay this is going to get a bit sloppy and flop around a lot, but try to bare with it. We need to add one ring through the first mobi segment making it a 3 mobi.
Step Three: Okay weíre going to repeat the same up two rings; donít reuse any rings from the first segment. We need this to form the center of the next mobi section.
Step Four: Continue this pattern to the end of your 2 in 1 chain.
Step Five: Repeat steps 2-4 on all the 2in1 chains you have made up for this project.
Step Six: We are going to start connecting them together now. It may help to lay them down on a table or flat surface to see the intersections better. Taking the ring we added in step two of the second chain segment, we need to connect it through the first 3 ring mobi of the first chain. Donít add this ring through the mobi of the second chain, just the outer ring connection.
Step Seven: Continue on with the completing of the four ring mobi segments down the length of the sections.
Step Eight: Your piece should now look like this and be a fair bit more stable, though still a bit floppy.
Step Nine: Continue steps 6-7 until you have a good amount connected to each other.
Step Ten: Now we have to finish the end off. This is done in the same way as steps 6-7 but without the added section.
Step Eleven: Done, pat yourself on the back.. :P
Original URL: http://www.mailleartisans.org/articles/articledisplay.php?key=578